Every winter on the South Shore, the same calls come in: icicles hanging off the gutters, water dripping through a ceiling, a downspout split open from ice. Many homeowners grab a heat tape kit from the hardware store. Some of those kits help. Some fail in the first cold snap, and a few create new problems. Here is what to know before you put heat tape on your roof or gutters.
What Heat Tape Actually Does
Heat tape (also called heat cable or de-icing cable) is an electric cable that warms a narrow path along your roof edge, inside your gutters and down your downspouts. It does not melt all the snow on your roof. Its job is to keep a drainage channel open so snowmelt can run off instead of refreezing at the cold eaves and backing up under your shingles as an ice dam.
Heat Tape Kits vs. Self-Regulating Heat Cable
There are two very different products sold under the same name:
- Constant-wattage heat tape (most retail kits) puts out the same heat whenever it is plugged in. It comes in fixed lengths that cannot be cut, and the cable must never touch or cross itself, because overlaps create hot spots that can melt the jacket.
- Self-regulating heat cable (such as nVent RAYCHEM WinterGard Wet) automatically turns its heat up in ice and snow and down as it warms. It is cut to the exact length of your gutters and can safely touch or overlap, which matters inside downspouts and on gutter guards.
Self-regulating cable costs more up front, but it uses less power, is safer, and typically comes with a much longer manufacturer warranty.
Why Heat Tape Often Fails on Gutters With Guards
If you have perforated aluminum gutter guards, heat tape inside the trough is not enough. Slush freezes across the screen holes, so roof meltwater sheets right over the frozen guard and forms icicles on the front of the gutter. The fix is a dual run: one pass of cable inside the gutter and one along the top of the guard, which melts a path for water to get through the screen.
The Outlet Problem Nobody Mentions
Household outdoor GFCI outlets trip at about 5 milliamps. Heat cable can leak a small amount of current in cold, wet weather, so a kit plugged into a standard outlet may shut itself off right when you need it. Professional systems use a power connection kit with 30 mA ground-fault equipment protection, which is what the electrical code calls for on de-icing equipment and avoids nuisance tripping.
What Does Heat Tape Cost to Run?
A typical 125-foot self-regulating system draws roughly 750 to 1,000 watts. At $0.20 per kWh, that is about $3.60 to $4.80 per day if it runs around the clock. Most homes only need it during snowstorms and freeze-thaw stretches.
Signs Your Home Needs Heat Cable
- Icicles forming along the same gutters every winter
- Ice dams or water stains on ceilings near exterior walls
- Downspouts that freeze solid or split
- Gutters on the north side or under shade that never thaw
Heat cable treats the symptom. If ice dams are severe, attic insulation and ventilation are also worth checking, since heat escaping into the attic is what melts the snow in the first place.
When to Install
Install before the first hard freeze. Heat cable prevents ice from forming; it will not remove a thick ice dam that is already there.
Get It Done Right
Up The Gutter installs commercial-grade RAYCHEM WinterGard Wet self-regulating cable across Plymouth County, Norfolk County and the Upper Cape, cut to fit and dual-run on guarded gutters. See our roof and gutter heat cable installation page or call 781.204.1248 for a free estimate.
Request Your Free Estimate
Have a question about your gutters, roof or drainage? Fill out the form below and Up The Gutter will reach out to schedule a free on-site estimate. Prefer to talk? Call 781-204-1248.
